OS Spindown of matrix RAID volumes causes hang rstcli.exe, rstcli64.exe allow to create recovery volume consisted of SATA and NVMe disks DevSlpRegEditTool creates reg keys with invalid disk product_id Cannot boot to OS after creating RAID1 out of two data drives while preserving an MBR partition table EFI CLI config disk status does not show system disk information Incomplete serial number of drives is output when using the /ST switch Partition table is not preserved when using the /U switch PCIe NVMe SSD 2DR0 (2-disk RAID 0) performance lower than pass-through single SSD RAID0 created using legacy OROM missing metadata on one of the drives Removing the lowest numbered driver causes BSOD. Error message display when run NvCacheScripts S4 hang black screen with certain NAS HDD under 2DR0 / 3DR5 SRT mode change to Enhanced, after setting Maximized mode and reboot PC. BSOD 7E caused by iaStorA during cold boot stress test cause BSOD Critical_Process_DIED during Sx If use HDD larger than 1.3TB build recovery without show an error message when CSM disable. No RST support for PCIe storage devices in AHCI mode. Issue with detecting PCIe storage when remapping is enabled on HM170/QM170 is fixed with the Pre-OS build 14. RST 14.6 release enables support for new platforms & features (includes legacy support for platforms and features supported in RST 14.5): Skylake mobile U/Y Corporate Platform, SKL-U 2+3e Platform and Support for NVMe API The Devslp tool is posted under the CLI tool components on VIP kit. The RAID OROM & UEFI version for this release is 14., the driver and user interface version is 14. Known Issue is defined as a potential RST issue that has been replicated internally by the Rapid Storage Technology team but has not been root caused to be an RST defect. This download is valid for the products listed below: RAID 1 going into 'failed' state during copying files to the volume. Extremely low performance during copying file to RAID volume with PCIe AHCI SCSI Compliance Test 2.0 fails with NVMe disks Cannot create RAID/SRT when RTD3 is enabled in BIOS BSOD 0x9F occurred as reboot system after finishing Burn-in tool (4 hours) (add HDD R/W loading) test Recovery volume can’t be built in IRST when the secondary hard drives size is the same as the prim Trim doesn't work on RAID0 on SATA SSD disks BSOD/Hung observed while resuming from CS with PCIe AHCI drives in remapped state IAStorUI has stopped working" when click 'Manager' tab (Unit with M2 PCIe SSD) with no empty port available
0 kommentar(er)
